However, I have noticed a considerable difference in the
price
of 2 cycle oil which makes you wonder what you are getting
additional
for the
higher priced stuff. For example a gallon (U.S) of Pennzoil
Marine Synthetic is USD $18.57 a gallon. AMZOIL on the
other hand for
their
ATC-01
2 cycle oil is $30.60 a gallon.
And I've been using Super Tech from Wal-Mart for $5.94 a gallon
in my
'87
RX-7. Been using it for two years now after Paul mentioned he
had seen
it
in his local Wal-mart. It solved the problem that I had with
the sticky apex seals, but I'll not know what else it may have
done 'till I rebuild
it
just before I put it in the Long Ez.
But, so far as far as I'm concerned...it's putting a burnable
oil in the
gas
that does the trick, instead of injecting regular motor oil,
regardless
of
the brand or "additives". It meets the TC-W3 oil spec...anything
else needed?
Harley
Hi Harley, based on your comment about Super Tech and its reasonable
price I went checking further.
It appears that it is a Pennzoil 2 cycle with Super Tech as the
Wal-Mart Brand name. See this registration for the oil:
R-99343A WAL-MART SUPER TECH OUTBOARD 2-CYCLE OIL TC-W3
PENNZOIL-QUAKER STATE
I intend to go check it out and see if I can find a difference
between its $5+ /gallon cost vs the $18+/Gallon Marine Pennzoil
since both are a 2 cycle oil apparently made by the same company.
Ed Anderson
Hi Ed, Tracy, and Guys (and Girls),
I thought that I would also post this to ACRE for those who don't subscribe to both
lists.
I raced motorcycles for 20 years (no kidding!!!) and worked as a professional
motorcycle mechanic while I was in college. Up until about 4 years ago the 2-stroke
was KING in motorcycle racing. We went to extreme lengths to promote both
longivity and HP, which are obviously at odds.
Let's take a moment to look at the 2-stroke beast to help us understand the oil and
cooling requirements. Since a 2-stroke fires on every revolution, there is less TIME
for the piston, head, cylinder and spark plug to cool down between firing events.
Due to this, spark plug heat range is very important (it can't be to hot or it will not
have time to cool between firing) but more importantly, the piston and rings must
have time to cool down. Well, since there isn't much time (that ugly word again) the
piston runs very hot so we are forced to run a very rich mixture (up to a bsfc of
about .65) to cool the piston and rings. If the heat gets a little out of hand, you will
burn a hole thru the top of the piston crown (as me how I know this!) - the piston gets
REALLY hot. OK, now for where I have been leading you - the piston is very hot
which causes the oil to burn off leaving deposits on the rings and in the ring lands.
This of course causes the rings to stick and compression disappears. What does oil
have to do with this you ask? Well, the oils formulated for air cooled engines fight
these deposits much better at the higher temps. But they are not as suited to a
cooler environment because they will not burn completely and then gum up the
engine. The oils formulated for water cooled engines have the opposite problem -
They burn great at the lower temps but leave deposits in the really hot
environments. I found that a synthetic called Golden Spectro seemed to work best
in both my water cooled bikes and the air cooled bikes (I rode both depending on
whether it was moto cross or cross country events). Strangly enough, the worst
condition of all for the rings was an overly rich fuel/air mixture because the egt's
would stay so low that the rings would gum up. I never did find a cure for that
except to pay attention to the jetting.
We are told that the apex seal runs at ~ 500 degrees so I believe that an oil
formulated for water cooling is better suited for our task. I will probably run Walmart
Outboard oil - I just don't think that we are stressing the capabilities nearly as much
as the 2 stroke outboard motors so why pay more.
BTW, I wil be running Golden Spectro in my Kawasaki powered miniMax when I
get it finished.
Ken Powell
To add a little evidence Tracy complains that the oil level in his pan increase
as time goes on as unburned apex seal 2 cycle oil finds its way into the pan.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org