Subject: Twin rotor motor tranny? PT6 reducers?
From: ACRE NL
Date: 3/17/2002, 11:34 AM


 > > >>  Ken we just realized what this message was all about.
 > > >>  We have been looking at a way to run a pair of rotary's together
 > > >>for a helicopter
 > > >>
 > > >>  engine.
 > > >>  Do you have any more details, pictures, drawings etc on this setup.
 > > >>  Royce


 > >   From Ken Welter
 > >
 > >    Unfortunately as a eyeball engineer most of the blue prints are in
 > > my head and I have not found a modem cable to download it into my
 > > computer yet but I will give you the basics of it. The key is to stop
 > > resonant vibrations and to do this I mounted the engines separately
 > > on rubber mounts rather than mount the engines solidly together and
 > > then rubber mount them as a package. That is the reason for the CV
 > > joints and axle so they can float independently and also run the
 > > engines and different RPM's. Ideally have two different types of
 > > engines so that they have different resonant frequency's. That
is also why
 > > I say run a 12a and a 13b. I would run the 12a at say 6500 rpm while
 > > the 13b would be at 5500 to 6000 rpm.
 >
 > >   As for the clutches I ran a sprag on the Rotax, that is the drum
 > > looking thing that the CV joint is connected to and I ran a dog
 > > clutch on the Mazda but that would not work for your application. You
 > > would need a sprag on both. For information on sprags check out a
 > > Morse catalog. They have all the engineering data on them also if you
 > > need custom pulleys I make them for the redrives that I  sell check
 > > out my web page at http://homepage.mac.com/rotarycoot/


 Have you ever tested a gebo to see if that would eliminate the harmonics?
 How wide is your redrive belt, and how much power can it transmit?
 Royce

  From Ken Welter
  No I have not there is no harmonics with this set up and I would
like to add that with this setup I use both engines for takeoff and
climb out and then shut down the rotax for cruise and it is a spare
if I need it, as for the belts they are 85mm wide and I run 100 hp
nitrous jets at 7000 rpm so I would guess that is about 300 hp but I
would like to say 200 hp is the limit continues for the 20B I would
use a 120mm belt.

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org