Very surprising Kelly. The Cosmo engine must be a different
animal.
After
some devcon port matching, I bolted my old 6 port lower manifold
to
my 89
turbo 4 port with no problems. Let us know what the differences
are
when
you get a handle on it.
Tracy Crook
Snip
Tracy,
I have not seen the intake manifold bolt pattern for the
93-95
13BREW
but I suspect it is the same as the 13B Cosmo. Speak up somone that
knows because
Tom's new manifold with current bolt pattern may not fit engines
with
13BREW or
13B Cosmo side housings. Are you listening Chrissi? I thought your
13B
used 93-95
side housings. One way to put this question to rest is for me to
buy a
13BREW
intake gasket.
Kelly
Here is a picture of my wife's 94 13Brew recently removed from her car
for a rebuilt engine. It was a fun job installing that mother-you gotta
try it sometime. Since I have a vested interest in seeing if the
manifold fits, I send this along!
Paul, I think quite a few (more than I realized) have the tt 13B 93+
engines from the manifold responses. I was surprised. In any case I have
2 late model FD engines here and a 20B. Plans are to use all of them.
And I may want two of those intake manifolds (if they fit), not just
one!
I see 7 bolts for the lower intake manifold.
And, a word of advice to all installing the manifold-MAKE sure you get
the latest steel gasket. What you see here is the oem plastic intake
gasket, a real piece of crap. What you want is a multilayer steel type.
Mazda has it as a superceding part number. BTW, this metal type gasket
is for ALL model 13B engines-just different part numbers.
[Marc Wiese]
Looks like it will fit to me. Send me a gasket Marc I will check.
I'll send it back after I draw it up.
Paul
The mystery is solved Paul. I can tell from Marc's photo of his 13BREW-TT
that the 13B Cosmo twin turbo shares the same side housings and use the same
intake manifold gasket. I did not had a chance today to buy the 13BREW gasket
to verify this. Thanks Marc! Boils down to this guys and gals. All four port
13B turbo engines from 87 to 91 have the same intake manifold bolt pattern. The
6 port 13B (naturally aspirated) engines from 86 to 91 share the same bolt
pattern as 87-91 turbo engines but have one less bolt in the top center of the
manifold (above the primary ports). This is no problem though as the new intake
from Tom should bolt right on to the 6 port.
The 93-95 and Jap Cosmo engines will need a different bolt pattern unless the 87-91
pattern can be used by matched hole duplicating. I believe just the top left and right
holes are different and the rest of the bolt pattern is the same as the 86-91. I have
not verified this so take this with a grain of salt until you hear more from me or
others on the list.
Kelly Troyer
Yes here is a picture of the six port flange overlaid on a 1988
four port turbo.
Send me a 93 gasket when you get it. I checked my stock of manifolds and
did not find anything that looked like a 93 or later.
BTW the picture of Marc's manifold reflects the fact it has been ported
so those are not the stock size ports I think.
Paul Lamar
Opps forgot the picture.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org