> > Ken Welter wrote:
> >
> > This is a trick that Rob Golden at Pineapple racing turned me on to.
> > He did dyno testing and found 15 degree drop in oil temp measured
> > before the cooler by doing this, you drill out the plug in the side
> > of the front housing and tap it to take the oil strait out of the oil
> > pump to eliminate all the small oil passages and 90 degree bends in
> > the front cover also do away with the banjo on the return line in the
> > rear housing and put it strait in a banjo is twice as restrictive as
> > a 90 degree bend so tap out the oil cooler and run it strait out
> > there to if possible if not run a 90 instead of the banjo.
>
> Ken shorter sentences please. Thanks.
>
> Paul Lamar
Sounds great if it drops oil temp by 15F. I wonder whether it might lower
oil flow to things like the injector oil pump - not a problem if you don't
use one, I suppose. Since the oil pump housing oils the chain - no problem
there. Does this mean the infamous front cover "O" ring problem will no
longer be a problem? Will the oil pressure controller valve still function?
I presume if the engine lives under racing conditions then the mod does not
have an adverse side effects.
Ed Anderson
>From this it looks like the oil metering pump gets oil from the top
oil gallery.
Paul Lamar
From Ken Welter
I have been just plugging the outlet on the front cover but beings I
am not using the injector I was considering plugging the galley at
the o ring but that would eliminate the pressure control valve, any
thoughts on how important that valve is.
Ken I don't know of anybody that has tried it. Sounds scary.
BTW look at the back side of a front cover. Notice that the oil injector pump
is fed from the upper main oil gallery so doing away with the o-ring and feed to
the pressure control valve would not affect the oil injector pump.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org