Got the manifold Tom. Heading out to the hanger to check
it on the turbo engine. Looks great. The flange is
0.65 inches thick so .15 inch off that will reduce the weight
a bunch. I can do that on my mill.
Also looking it it from the outside the left core box
runner could be .1 inch larger in dia where it mates the
pipe. More suggestions when I get it on the engine.
Here is a six port flange overlaid. It is going to work
great with a six port engine. Even if it is wildly ported.
Plenty of meat in this thing for some wild porting.
You did a great job Tom. Thanks a bunch.
Paul Lamar
Glad to hear it is looking up. I just finished up a 4.5 day marathon (1
meal / day, 20 hours / day) swapping the engine in my Dodge truck. It's one
of those boing-boing engines, and although it lasted 170,000 miles, it was
starting to loose compression and milage was suffering. Time for a rebuild.
It was a lot harder than I thought. Many mistakes and back-tracking. But
now I'm trying to get caught up on my e-mail again. Now if I could just get
all the grease and oil cleaned off my hands and garage floor!
Tom
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org