To add a little evidence Tracy complains that the oil level in his pan
increase
as time goes on as unburned apex seal 2 cycle oil finds its way into
the
pan.
Paul Lamar
Hi Paul,
I see Tracy told you about his "Oil producing" engine. He swore me
to
secrecy as I am certain he though he would catch unmerciful ribbing from
you
if he went on the list claiming his engine was producing oil {:>). I
have
noticed my oil level never decreases and may even be slightly
increasing. I
guess if you went long enough between oil changes you could get to the
point
that the lubricating oil in the crankcase might get too diluted with the
2
cycle oil to provide good protection. But, at my rate of oil level
increase
oil change will come long before than happens. Another bonus point for
the
rotary?{:>).
Ed
I would not worry too much about it. Regular motor oil has high pressure
"secondary lubrication" additives mainly for rubbing wear such as cam
shafts,
lifters and valve stems that are not needed in a rotary. Zinc and
phosphor come
to mind. When burnt I suspect these are what cause most of the gunk on
the rotors.
Paul Lamar
Paul, my Ross drive needs that secondary lubrication. Tip. motorcycle oils
contain more phosphates than car oils for extreme pressure lubrication
Phosphates are bad news for catalytic converters in cars.
I am using Mobil 1 plus a teflon additive. My rotary does not 'produce oil'
Happy flying
Ian RV6A Down under.
Good point Ian. I forgot about the gear box.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org