Wrathall Mark wrote:

Mark Wrathall wrote:

I visited Brian Trubee in Seattle last week. Had a great time talking
rotaries and sitting in his RV-4. Thanks Brian. It's going to be a

beauty!

He took me down to Boeing surplus! Boy now I understand when my wife

says

shopping is fun:).

Last night's jet lag (woke up at 2am) got me thinking about some oil

system

details that Brian and I touched on.

He is machining an adaptor plate to fit the oil filter mount plate and
connect up hoses to an remote filter. I figure you could use one less

hose by

plumbing block-cooler-filter-block, and them just making a blanking

plate

for the oil filter mount milled to connect the oil ports.

Checking the schematic, indicates the following consequences:
1. One less external oil line.
2. Oil lines shorter as the filter will likely be located back by the

cooler

any way.
3. Easier routing, no need to route two tubes back past the

intake/ignition.

4. Filter sees unregulated px instead of regulated.
5. Failure or wear of the regulator could cause system debris.

Point five seems to me to be a very unlikely failure mode. Anyone have
experience or comments on this.

My second thought was concerning maintenance. Those of you putting

radiators

under the engine (Brian/Mike/Paul...) have you made any provision for

oil

changes? Are you planning on an oil drain valve with hose overboard,

or

just

accepting a radiator drain and removal each oil change?

Mark Wrathall

I have the same problem in my 182. The oil drain plug is just above the

muffler

so I plan on using a hose out of the bottom of the pan with a plug on

the

end.

Paul Lamar

With the oil warm you can suck it out of the distick hole with a hand

pump.I

do both my cars and the RV this way. Nice and clean too- staight into the
waste container.
Ian RV6A.

Good idea Ian.
Having seen any comments to the idea of plumbing the oil filter into the
cooler return line.
Mark Wrathall

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org