Here are some captures of RB Wagner catalog on the right
bends to buy. This is the three inch radius stuff.

I think if you shop around you can get better
prices from RB Wagners distributors than you can direct from RB Wagner.

http://rbwagner.com/

I checked and they don't appear to have .065 in stock. All they
stock apparently is sched 40 which according to the drawing is
.140 thick. When I measure it it is more like .125 thick.


We might be able to get a quantity buy of custom .065 wall if people are

interested.

Also we could specify a longer straight leg or even a jog at the end
for the fuel injector similar to this drawing of my Kis installation.
Save a lot of pipe welding. And be a bit lighter.

Anybody interested in pursuing this?

Paul Lamar

Mike Collier wrote:

"In for a penny in for a pound".  Paul, would the tubes come pre cut/bent
and ready for installation on the intake?  If so, I'm interested, count me
in.

Thanks
Mike C.

Yes. If we get enough interest we will send out a drawing for a quote.
As a practical matter you might have to trim the end that plugs into
the casting a bit. If somebody knows a tube bender that does low cost
work we could try them as well as RB Wagner.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org