Here are some captures of RB Wagner catalog on the right
bends to buy. This is the three inch radius stuff.

I think if you shop around you can get better
prices from RB Wagners distributors than you can direct from RB

Wagner.

http://rbwagner.com/

I checked and they don't appear to have .065 in stock. All they
stock apparently is sched 40 which according to the drawing is
.140 thick. When I measure it it is more like .125 thick.


We might be able to get a quantity buy of custom .065 wall if people

are

interested.

Also we could specify a longer straight leg or even a jog at the end
for the fuel injector similar to this drawing of my Kis installation.
Save a lot of pipe welding. And be a bit lighter.

Anybody interested in pursuing this?

Paul Lamar

Mike Collier wrote:

"In for a penny in for a pound".  Paul, would the tubes come pre

cut/bent

and ready for installation on the intake?  If so, I'm interested, count

me

in.

Thanks
Mike C.

Yes. If we get enough interest we will send out a drawing for a quote.
As a practical matter you might have to trim the end that plugs into
the casting a bit. If somebody knows a tube bender that does low cost
work we could try them as well as RB Wagner.

Paul Lamar

Mike Collier wrote:

sounds like a plan, count me in.

Mike C. 

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org