Subject: Right bends for intake manifold.
From: ACRE NL
Date: 3/21/2002, 12:38 AM


Here are some captures of RB Wagner catalog
on the right
bends to buy. This is the three inch radius
stuff.

I think if you shop around you can get
better
prices from RB Wagners distributors than you
can direct from RB
Wagner.

http://rbwagner.com/

I checked and they don't appear to have .065
in stock. All they
stock apparently is sched 40 which according
to the drawing is
.140 thick. When I measure it it is more
like .125 thick.


We might be able to get a quantity buy of
custom .065 wall if people
are
interested.
Also we could specify a longer straight leg
or even a jog at the end
for the fuel injector similar to this
drawing of my Kis installation.
Save a lot of pipe welding. And be a bit
lighter.

Anybody interested in pursuing this?

Paul Lamar


Mike Collier wrote:

"In for a penny in for a pound".  Paul, would
the tubes come pre
cut/bent
and ready for installation on the intake?  If
so, I'm interested, count
me
in.

Thanks
Mike C.


Yes. If we get enough interest we will send out
a drawing for a quote.
As a practical matter you might have to trim the
end that plugs into
the casting a bit. If somebody knows a tube
bender that does low cost
work we could try them as well as RB Wagner.

Paul Lamar

Mike Collier wrote:

sounds like a plan, count me in.

Mike C.

I'll need them also.  Jim Coffmanus@yahoo.com

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org