Barnhart wrote:

Paul,

I'm interested in the right bends for my 20b.   Would Tom set up the 20b intake manifolds so that it would work with a 13bs  right bends? Would a short piece of flexible tubing be ok to use as an adapter between the intake manifold and injector tube? Vibration?

Definitely interested, but don't put me down for any yet.

Barny

I think tom is planning on a 20B version of the casting. Yes the same bends could be 
used on the 20B. You would need six of course.

If we lump in the 20B requirements our cost should go down a bit as we would
be looking at a 100 piece order.

Paul Lamar


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org