Yes. If we get enough interest we will send out a drawing for a quote.
As a practical matter you might have to trim the end that plugs into
the casting a bit. If somebody knows a tube bender that does low cost
work we could try them as well as RB Wagner.
Paul Lamar
Mike Collier wrote:
sounds like a plan, count me in.
Mike C.
Me too!
Bulent
This essentially is the drawing of the bent tube. Any suggested improvements?
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org