Subject: Right bends for intake manifold.
From: ACRE NL
Date: 3/21/2002, 8:28 AM


Paul wrote;

This essentially is the drawing of the bent tube. Any suggested
improvements?

Paul Lamar

Mark wrote:
Looking down from above, don't you need slight bends (two LH and two RH
tubes) to deal with the angles coming out of the casting?

Please send some more pictures of the protype mocked up on your engine -
just cause it makes nice eye candy :) Good effort Tom.
Mark Wrathall

Good observation Mark. The answer is "no" :-). But you do need to twist the
right angle as the straight sections are horizontal and the 45 degree 
down sections are parallel.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

on-eng-with-turbo.jpg