Subject: Right bends for intake manifold.
From: ACRE NL
Date: 3/21/2002, 9:55 AM


Paul wrote;

This essentially is the drawing of the bent tube. Any suggested
improvements?

Paul Lamar

Mark wrote:
Looking down from above, don't you need slight bends (two LH and two RH
tubes) to deal with the angles coming out of the casting?

Please send some more pictures of the protype mocked up on your engine -
just cause it makes nice eye candy :) Good effort Tom.
Mark Wrathall

Good observation Mark. The answer is "no" :-). But you do need to twist
the
right angle as the straight sections are horizontal and the 45 degree
down sections are parallel.

Paul Lamar


Hi Paul,

    I know Tommy has had his hands full with his truck overhaul, etc. but,
do you have any plan/schedule for completing an initial orders list?  I
think its clear you could start firming up orders as we speak. It would be
nice to get the first batch or manifold orders in before heading to Sun &
Fun - not too far off.

Ed Anderson

Ed Anderson

We are on hold here for a few days while we investigate the 93 and later
13B situation. We may make a few minor modifications to the patterns.
Also I am in the process of getting more quotes on the casting and machining.

I don't think that will happen before Sun & Fun but I will bring the
manifold with me for all there to see.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org