> Barnhart wrote:
     >
     > Paul,
     >
     > I'm interested in the right bends for my 20b.   Would Tom set up the 20b intake manifolds so that it would work with a 13bs  right bends? Would a short piece of flexible tubing be ok to use as an adapter between the intake manifold and injector tube? Vibration?
     >
     > Definitely interested, but don't put me down for any yet.
     >
     > Barny

     I think Tom is planning on a 20B version of the casting. Yes the same bends could be
     used on the 20B. You would need six of course.

     If we lump in the 20B requirements our cost should go down a bit as we would
     be looking at a 100 piece order.

     Paul Lamar

Can anyone give a good extrapolation of the weight for a 20B flange?
Thank-you,
-
Chris
microcosman.com

The current manifold casting is about 4.5 pounds so 50% more would be
about 6 3/4 pounds.

Paul Lamar 
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org