Subject: Right bends for intake manifold.]
From: ACRE NL
Date: 3/22/2002, 9:04 AM

Wrathall Mark wrote:

Mark wrote:
Looking down from above, don't you need slight bends (two LH and two RH
tubes) to deal with the angles coming out of the casting?

Please send some more pictures of the protype mocked up on your engine -
just cause it makes nice eye candy :) Good effort Tom.
Mark Wrathall

Paul wrote:
Good observation Mark. The answer is "no" :-). But you do need to twist the
right angle as the straight sections are horizontal and the 45 degree
down sections are parallel.

Paul Lamar

Mark wrote:
I thought you were talking about having the 90° bend and the 31° bends put
in in one peice of pipe to reduce the jigging/welding requirements. In that
case the rotation around the lateral axis (as seen in the aircraft) would
cause the 31°  bends to be out of the vertical, so the runner openings would
no longer be parallel.

If you are doing custom bends, will you optimise (enlarge) the bend radius
of the 90° bends to hug the engine profile a little closer?
Mark Wrathall.

Looking down from the top and starting at the cold side of engine the pipes 
are totally parallel until you get to the 90 degree bends. The big pipe goes
off to the right and the little pipe goes off to the left looking at the front
pair of pipes in a tractor installation.

"will you optimize (enlarge) the bend radius"
There is a problem with that. Mandrill bends come in various radii so three
inch is a better fit than two inches. Three inch fits the engine pretty
good but not perfect as the rotor housing radius is about 5 inches.
Three inch also leaves a bit of straight section where it sockets to the
casting so the height of the pipe can be adjusted somewhat to just clear
the top of the rotor housing. Also the vertical location of the manifold
(I am coming to believe) is going to vary as the 93 and latter engines have 
the ports located on the end housings about 25 mm higher. I think.
I'll know more in the next couple of days.

As I mentioned to Ed this design allows
a bit of flexibility in the exact location of the pipes.

This dwg is more or less the design we started with. The pattern for
this turned out to be too costly so we went with a 90 degree 
design also shown here. I am now glad we did because we now have
the potential to make this manifold fit the 93 and still keep
the pipes right down on top of the rotor housings.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

TURBOMA3.GIF

TURBOMA4.GIF