Subject: Right bends for intake manifold.
From: ACRE NL
Date: 3/23/2002, 12:21 AM


 Here are some captures of RB Wagner catalog on the right
 bends to buy. This is the three inch radius stuff.

 I think if you shop around you can get better
 prices from RB Wagners distributors than you can direct from RB
Wagner.

 http://rbwagner.com/

 I checked and they don't appear to have .065 in stock. All they
 stock apparently is sched 40 which according to the drawing is
 .140 thick. When I measure it it is more like .125 thick.


 We might be able to get a quantity buy of custom .065 wall if people
are
interested.
 Also we could specify a longer straight leg or even a jog at the end
 for the fuel injector similar to this drawing of my Kis installation.
 Save a lot of pipe welding. And be a bit lighter.

 Anybody interested in pursuing this?

 Paul Lamar


Depending on cost, I would be interested also. Are you talking about 1
piece
that goes from cast manifold to injector area?

Bill Schertz
KIS Cruiser #4045


Yes. One piece. One thing we have going for us is each manifold requires
4 pipes. That means it take forty bent pipes for ten manifolds.
That is a fair order for most benders so we should get the price
down to less than $10 to $15 a bend they are charging now for individual
bends. Also as I mentioned if you have to farm out the tig welding that
too
would be a savings.


As well as this project is proceeding, I'm thinking that the 20B manifold
should follow the same pattern.  Which means the same bends, just two more
of 'em!  So tentatively, count me in for tubing bends.  6 to go please!

Tom Kendall

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org