Subject: Inspecting used tension bolts for cracks at the root of the threads.
From: ACRE NL
Date: 3/25/2002, 12:28 AM

I was wrong about this being impossible. It is merely difficult.
Weld a nut to a steel plate making a blind taped hole.
Screw the tension bolt into this blind taped hole
until it bottoms out.
Install an accelerometer on the head of the bolt.
Tap the bolt with a hammer.
Use an oscilloscope to measure the resonant frequency.
Compare that resonant frequency with a new bolt resonant frequency.
The cracked tension bolt will have a lower frequency.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org