Subject: Right bends for intake manifold.
From: ACRE NL
Date: 3/24/2002, 2:30 PM


     > > > >  Here are some captures of RB Wagner catalog on the right
     > > > >  bends to buy. This is the three inch radius stuff.
     > > > >
     > > > >  I think if you shop around you can get better
     > > > >  prices from RB Wagners distributors than you can direct from RB
     > Wagner.
     > > > >
     > > > >  http://rbwagner.com/
     > > > >
     > > > >  I checked and they don't appear to have .065 in stock. All they
     > > > >  stock apparently is sched 40 which according to the drawing is
     > > > >  .140 thick. When I measure it it is more like .125 thick.
     > > > >
     > > > >
     > > > >  We might be able to get a quantity buy of custom .065 wall if people
     > are
     > > > > interested.
     > > > >  Also we could specify a longer straight leg or even a jog at the end
     > > > >  for the fuel injector similar to this drawing of my Kis installation.
     > > > >  Save a lot of pipe welding. And be a bit lighter.
     > > > >
     > > > >  Anybody interested in pursuing this?
     > > > >
     > > > >  Paul Lamar

     > > > Depending on cost, I would be interested also. Are you talking about 1
     > piece
     > > > that goes from cast manifold to injector area?
     > > >
     > > > Bill Schertz
     > > > KIS Cruiser #4045

     > > Yes. One piece. One thing we have going for us is each manifold requires
     > > 4 pipes. That means it take forty bent pipes for ten manifolds.
     > > That is a fair order for most benders so we should get the price
     > > down to less than $10 to $15 a bend they are charging now for individual
     > > bends. Also as I mentioned if you have to farm out the tig welding that
     > too
     > > would be a savings.

     > As well as this project is proceeding, I'm thinking that the 20B manifold
     > should follow the same pattern.  Which means the same bends, just two more
     > of 'em!  So tentatively, count me in for tubing bends.  6 to go please!
     >
     > Tom Kendall

Yeah, me too.  Even if I do get a composite manifold figured out before the 20B casting is done, I can always use it on serial # 2

Thank-you,
-
Chris
microcosman.com

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org