Paul, one thing you might consider related to the turbo installation.
That
is perhaps to have the manifold cast with an indention or some other
indicator of where it should be drilled and tapped for accessing the
coolant
for the turbo - might save you getting a bunch of e mail asking where to
drill and tap. . I presume that an "O" ring around the hole would seal
it
or I guess the regular turbo manifold gasket would take care of that.
Now
that I think about it - that surface is going to be machined flat so
probably not worth the effort.
Ed Anderson
Good idea Ed. I will put an indentation in the pattern as soon as I get it
from Tom. It will be cast out here on the west coast by the guys
capable of doing stuff like this cast turbo air plumbing elbow
and turbo compressor housings. Here are a couple examples of their fine
work.
I asked them how they got such a great finish and were able to
do 0.140 thick walls and they said they had a secret recipe for the
casting sand developed over a period of thirty years. I wish Tracy had his
PSRU cast by these guys. We could knock five pounds out of the weight :-)
I think the gasket does the job.
Paul Lamar
That is some mighty fine thin wall castings - great finish as well. Now if
they are only reasonable in what they charge {:>).
Ed Anderson
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org