Subject: Ducted fans and turbofans
From: ACRE NL
Date: 3/27/2002, 12:01 AM


Yah all be careful out there! Actually flutter can rear it's ugly
head
at a
lot
lower speeds than 300. A Duster sailplane suffered a nasty crash
after
losing the vertical at less than 90mph. Also, if you lose a blade at
virtually
any time, you do not have enough time to shut down the engine before
it
is ripped from it's mounts. The good side to this is that well
designed
composite construction has better flutter resistance than almost all
other systems,

Speaking of 6000 rpm props, I promised to look at the difference
between
constant speed and fixed props in this range, and the results should
be
below. this was for a near stock Mazda with 160 bhp at 6000 rpm for
a 200mph capable plane on that power. The fixed prop was 34 inch
dia with about 42 in pitch. The constant speed was simulated by the
same blade area with the pitch changed to match speed. This is for a
clean installation, with free flow - interference from the fuselage
can severely degrade these predictions. The results are not half bad
for this little prop, and the gain from varible pitch appears less
than
what one would expect at a lower disk loading.
Vance J


Vance,

Thanks for looking at this problem. The real issue to me is whether the
engine produces enough torque to spin the fixed pitch prop up to speed
at
low forward speed. You would have to look at the power required vs.
power
available to find the operating point of the engine. Even if the engine
CAN
produce 160 hp at 6000 rpm, it may never get there because it does not
have
the torque to spin the prop to that rpm. As the forward speed increases,
the
operating point moves up the curve and you eventually get there. If you
took
this into account, then it looks like a small fixed pitch prop is
definitely
the preferable simple solution.

Monty


Nix that. Brain fade. That only works for big props. I looked at some prelim
designs. The biggest problem is that the prop winds up being stalled over a
large percentage (like all) of the blade at static conditions. There is
plenty of power to spin it up. It just stalls and stirs up the air. The
thing doesn't "hook" up until at least 100 mph. That doesn't give me the
warm fuzzies. Maybe I am looking at this wrong, but my preliminary numbers
don't look promising for a fixed pitch version. Large portions of the blade
would be stalled at climb speed. What's the secret? How did you arrive at
the graph? Give us a good design treatise here Vance.

Monty

Do I have the source code to this program Vance?

PRPLRIT3.BAS                                                                                       
Prplrit3.bas                                                                                               
PRPLRIT5.BAS                                                                                         
prplrit5.bas                                                                                      
Prplritf.bas                                                                                  
Prpsiz.bas      


Paul Lamar

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org