Subject: Ipac GPS connector?
From: ACRE NL
Date: 3/26/2002, 11:05 PM


The nice thing about RS232 connections is that
you can mess up the
wiring
and you won't hurt anything. I need to wire up
a gender mender in
order
to
get my GPS to work with the IPAQ. There are
gender menders out there
but
they won't work because they don't cross over
the TXD and RXD
cables.
If
you can find one that comes apart you might
buy the tool the pushes
the
pins
out so that you can move them on one of the
DB9 connectors.

Hopefully this will get you started.


Where does one find that peculiar (DIN?) connector
on the bottom of the
IPAQ? I haven't found one yet that I can purchase
somewhere. I use the
controlvision version gps on the ipaq and want to
try a few things. BTW,
I hear there are 2 versions of the connector
depending on the version of
IPAQ you own (I have a 3650 and use a Garmin gps
antenna/receiver
prewired to the ipaq).
[Marc Wiese]


go to ipaq on ebay.  several vendors sell both a
cradle and a cable ending in a 9 pin connector.  if
you don't want the 9 pin just snip.  jim coffman

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org