Leave the plate as is for now Blake. I can cut it on the bandsaw.
We still don't have a final answer on the bolt hole locations. Jerry
has my drilling jig and is looking into it.
What is happening there Jerry?
Paul Lamar
Tomorrow, Danny and I are getting together to nail down the bolt hole
locations which were slightly off from the CAD drawings. We also will
be setting up to make the Barry Isolater holders and the plate stand
off spacers. The whole package will be available by May. Jerry
OK Paul, no problem.
Now for the not-so-good news....
Took home the camera from work and took some shots of the plate before the last cut
was made. Done!
Pulled off the plate and cleaned it. Done!
Looked at it..... Hmmmm that looks a bit different than MMPLATE4's rendering on my
computer monitor.... Sorta offset a bit. Weird. Lets look back at the drawings. Uh
oh, a bit different.
The older drawing dated 11/06/2001 has the central hole dimensioned at 6.35" off the
lower edge. That is where the hole is! Put it in there shortly after I received the
plate and before the Z drive died. Went and looked at the geometry from the MMPLATE4
and did a data verification. Shit, 6.55 of the lower edge and a plate height of
14.25". The Plate measures a tad under 14". Shit^2!!!
Take a look at the photos Paul and tell me what you think. Looks like hole #8 will be
near the lower plate margin by an uncomfortable amount. A small amount of weld
material and a pass under the mill would restore adequate margin.
Blake
Nice work Blake. I can't tig weld 1/2 inch with only 150 amps so if you can get
that done there that will solve the problem. Send it to me and I will use
my current plate on the engine to match drill the holes and make another accurate
drawing in the process. Don't send it til after I get back from Sun & Fun.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org