Fred Vandeman wrote:
Paul....thank you for your comments. A couple of more questions.
I've
been on
ACRE NL for a couple of months and it seems that a great deal of
work
and
inovation is available to experimental aircraft builders for the two
rotor (12B or
13B)....but does this leave those few with the 20B at a
disadvantage?
I'm not an
engineer and would benefit by the experience talented experimenters
as
it applies
to the 20B. Motor mounts? Radiators and oil coolers? Is this help
available
through the chat room or Maxdatrix or others? If I do buy a three
rotor... how
much should I concentrate on also having the seller supply other
components
(electrical, computer controllers, radiators, etc.)? What is the
availability of
parts for rebuilding and maintaining? Thank so much for your
help.
fred vandeman> fvandeman@comcast.net
Velocity XLFG
Tracy Crook has a three rotor and he is building an RV8.
I will let him tell you what he will have available for the three
rotor.
Tracy?
With the possible exception of oil coolers, the 20B seller probably
would
not have anything else of use to an aircraft builder. The usual stuff
that
comes on the engine (intake manifolds, throttle body, fuel rails,
injectors,
etc) can be used when making your intake system. Don't bother getting
the
very rare coil & ignition modules for the 20B. They are very heavy. I
recommend using AC Delco coil/igniter modules (# D580) (6 required).
Order
from rockauto.com for good price.
I also make the RD-1B reduction drive for the 20B.
Tracy Crook
tcrook@rotaryaviation.com
www.rotaryaviation.com
I make a version of the EC2 EFI/Ignition controller for the 20B and
Try to get the flywheel/starter gear for it when you buy it! These are
available separately, but can be expensive. I'm learning the hard way.
Tom Kendall
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org