BTW Lynn I think you can get straight thread fittings with captured
O-rings under the head. There is a little groove under the head that
holds the O-ring. Then all you need do is counter bore the casting a bit
to square it up with the hole.
Yes, face seals of that type do a good job; why I brought up Swagelok in the first place, the fitting is called "O-Seal Straight Thread Male Connector" available from 1/16" to 1" tubing. They also have it with an O-ring in a short NPT thread, I would guess for an application where there is already an NPT thread but you would rather reley on the O-ring for the seal than the taper thread. Either way, good stuff.
...Chrissi
Cozy Mk-IV 13B-turbo
www.CozyGirrrl.com
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org