Subject: Direct out Oil line trick?
From: ACRE NL
Date: 3/27/2002, 3:11 PM


Here is another good trick.
Feed oil pressure into the front end of the e-shaft (crank) as trying to force
oil into a high RPM shaft through the main bearings is a losing situation. Centrifugal force
is working against you. In the latter case the shaft is working like a
centrifugal oil pump helping the situation. I think Porsche came up with this idea.

Paul Lamar


  Roger that. Paul Trapp and Daryl Drummond had setups to measure oil pressure in the centerline gallery. Under 10 PSI if I remember correctly. So the engine builders would like to see 90-100 PSI at full tilt.
Racing beat has 115 PSI as their max. Cross drilled shafts and scoops ground into the oil passage sites all have been used. A little extra clearance on the bearings
both rotor and mains is good. With a big Peterson Gerotor pump we get 90 pounds at idle (2,000 RPM) and 65-70 PSI at 9,500 RPM hot. Not what we would like to see, but with extra clearance all around and 180 Webber main jets for E shaft nozzles we are running a huge amount of oil through every second. Daryl says for every degree of oil temp above 160 degrees, you loose 1 HP. So cooling is a real big deal. Also the strength of the rotor bearing material goes away at higher temps.
Lynn E. Hanover

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org