"F. J. Diekman" wrote:
I don't know if it will help you fellows but if you have fatigue problems
with bolts, cryogenic treatment of new bolts will greatly increase their
life. I wouldn't suggest it for used bolts, though, and don't just dip the
parts in liquid nitrogen, as you will cause your own cracks. Have it done
by a reputable specialist who will cool the parts slowly, soak them at -300F
for at least 8 hours, and bring them back up slowly. Then the parts should
be tempered.
I find that magnaflux does not have the resolution to detect early fatigue
cracks. They are too small to be seen, even under the black light. They
are also too small to be detected by ultrasonic methods. A crack is an
infinite stress concentration so virtually any crack can be a problem.
There is a theory that the cracks need to get to some mimimum size before
they become a problem, but nobody seems to know what that size is, and it
probably varies with material, heat treat, and application.
As for used bolts, if they check out to be crack free by magnaflux, you
might consider shot peening them. If you can get the layer of compressive
residual stress deeper than any existing but undetectable crack, you will
increase the life of the bolt and possibly stop the crack.
Rick Diekman
I don't think you can shot peen the threaded area where they break.
If they are not cracked and you re-install them coated with RTV they
don't break as the RTV cures and damps the offending vibration.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org