Subject: Direct out Oil line trick?
From: ACRE NL
Date: 3/28/2002, 9:46 PM


 > > Ken Welter wrote:
 > >
 > > >  > > > >>This is a trick that Rob Golden at Pineapple racing turned me
 on
 > > >>  to,
 > > >>  > > he did dyno testing and found 15 degree drop in oil temp
 measured
 > > >>  > > before the cooler by doing this, you drill out the plug in the
 side
 > > >>  > > of the front housing and tap it to take the oil strait out of
 the
 > > >>  oil
 > > >>  > > pump to eliminate all the small oil passages and 90 degree bends
 in
 > > >>  > > the front cover, then  you plug the outlet on the front cover,
 this
 > > >>  > > way you can still use the injector if you wish and the pressure
 > > >>  > > relief valve functions as normal, Also do away with the banjo on
 the
 > > >>  > > return line as it is very restrictive.<<
 > > >>  > > Ken Welter
 > > >
 > > >>  > Yes, it works very well and there is one thing to be careful of.
 The
 > > >>  > front [end-house] plate is fairly thin in the area of the new
 > > >>outlet.  If you
 > > >>  > overtighten the fitting into the plate it'll crack the plate.
 Rob'll
 > > >>  > tell you how to best do this.  Fixing a cracked plate is a bitch!
 You
 > > >>  > have to remove the front cover and grind/weld the cast iron (not
 > > >>  easy).
 > > >>  > However, the resultant flow increase is phenomenal!  You can run 3
 > > >>  > window mains without worrying about oil supply at idle.  Those
 banjo
 > > >>  > bolts suck for main oil lines on a modded engine!
 > > >>  >
 > > >>  > I have this on my '90 GXL and would never go back unless I had to.
 > > >>  >
 > > >>  > Seth


 > >    The best way to install the fitting is to do it after the case and
 > > front cover are bolted together so you have the pressure squeezing on
 > > it and like I said use  high strength locktite so you don't have to
 > > torque on it hard.
 > >
 > >   Ken Welter


 > Ken why use a pipe thread? Why not a face seal fitting with an O ring
 seal?
 > http://www.hosexpress.com/hydraulic/adapters/oring.htm
 >
 > It won't put as much stress on the cast iron front cover when
 > it is torqued down.
 >
 > Paul Lamar


  Ken,
  I assume the internal pipe diameter has to be 3/8" or Mazda 10mm. If so,
 one trick is to use a 17mm flush fitting metric adapter which has 10mm ID
 rather than a NTP 3/8" fitting which is 18mm. This gives you 1mm more cast
 iron. Use an O ring with an alluminium washer around it, called a
 'Statoseal'. I looked at a 13B race car today. They use the same outlet but
 with a manifold. Don't ask how they hold it in position!
 Ian RV6A Australia.

   Yes I think that is a good idea as you are not trying to split the
case with a tapered pipe thread.
  Ken Welter

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org