Subject: Direct out Oil line trick?
From: ACRE NL
Date: 3/28/2002, 9:05 AM


Ken Welter wrote:

 > > > >>This is a trick that Rob Golden at Pineapple racing turned me
on
 to,
 > > he did dyno testing and found 15 degree drop in oil temp
measured
 > > before the cooler by doing this, you drill out the plug in the
side
 > > of the front housing and tap it to take the oil strait out of
the
 oil
 > > pump to eliminate all the small oil passages and 90 degree bends
in
 > > the front cover, then  you plug the outlet on the front cover,
this
 > > way you can still use the injector if you wish and the pressure
 > > relief valve functions as normal, Also do away with the banjo on
the
 > > return line as it is very restrictive.<<
 > > Ken Welter

 > Yes, it works very well and there is one thing to be careful of.
The
 > front [end-house] plate is fairly thin in the area of the new
outlet.  If you
 > overtighten the fitting into the plate it'll crack the plate.
Rob'll
 > tell you how to best do this.  Fixing a cracked plate is a bitch!
You
 > have to remove the front cover and grind/weld the cast iron (not
 easy).
 > However, the resultant flow increase is phenomenal!  You can run 3
 > window mains without worrying about oil supply at idle.  Those
banjo
 > bolts suck for main oil lines on a modded engine!
 >
 > I have this on my '90 GXL and would never go back unless I had to.
 >
 > Seth


   The best way to install the fitting is to do it after the case and
front cover are bolted together so you have the pressure squeezing on
it and like I said use  high strength locktite so you don't have to
torque on it hard.

  Ken Welter


Ken why use a pipe thread? Why not a face seal fitting with an O ring
seal?
http://www.hosexpress.com/hydraulic/adapters/oring.htm

It won't put as much stress on the cast iron front cover when
it is torqued down.

Paul Lamar

 Ken,
 I assume the internal pipe diameter has to be 3/8" or Mazda 10mm. If so,
one trick is to use a 17mm flush fitting metric adapter which has 10mm ID
rather than a NTP 3/8" fitting which is 18mm. This gives you 1mm more cast
iron. Use an O ring with an alluminium washer around it, called a
'Statoseal'. I looked at a 13B race car today. They use the same outlet but
with a manifold. Don't ask how they hold it in position!
Ian RV6A Australia.

The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org