Subject: Motor Mount - Pockets.... Done!]
From: ACRE NL
Date: 3/28/2002, 10:09 AM


Now to the price:
I think $400, pocketed plate, with the central 12 holes when we
figure
out where they
actually are... Or $500 with the starter hole, all other drilled
holes,
back side counter
bore for the shaft seal, and the curved upper 7.7" radius cut out
(straight cuts by the end
user from there - MUCH easier to cut with a saw!). Subtract $100 if
you
ship me a 14.25"
High X 27" Wide (this dimension can be modified) X .500" THK plate
made
from 6061 aluminum.

Now do people want flat bottomed or sculpted bottoms in the pockets?
Blake


Are you talking about the 1/4 inch holes that Tracy bolts his psru on
with?
If so I would guess they start at +15 degrees on a 5.875 bolt circ.
dia..
Is that correct Tracy? See the gif. Angle not critical.

Flat bottoms are OK from a stress point of view.


Would Blake be amenable for a very similar but simplified version of
this plate I would be interested in? Uses all the same Tracy PSRU data
(central holes), but different mount provisions, which I can do myself.
IOW, can this plate be mildly customized, as it sounds above?
[Marc Wiese]

Blake?

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org