"F. J. Diekman" wrote:
The limitations of shot peening as far as threads go are the size of the
shot. Smaller shot = thinner layer of compressive residual stress, and
lower values of stress. Obviously you can not use a large shot size and
expect to get down into the root of the thread. But using a very fine shot
size followed up with some fine glass beads will give you compressive
stresses in that area, and the double peening will give you extended fatigue
life. If you are worried about surface finish, again, the combination of
the small steel shot and the glass beads will give you a surface finish that
is acceptable. I have shot peened a lot of different items, including screw
threads when I owned a shot peening company, and it is a very under used
process for the benefits that can be had.
These bolts are like 5/16 24 or 8 mm metric equivalent.
That is real fine shot indeed.
The thread is M10 1.0
Royce
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org