Subject: Just made it back.Dave Garbers Reno racer.
From: ACRE NL
Date: 4/17/2002, 6:56 PM

We left Sun & Fun on Wednesday to tow Dave Garber's 330 HP dual 1975 12A turbo's airplane 
back to his home in Leesburg Florida. Looked like bad weather for the rest of the week
anyway and some officials at Sun & Fun were complaining about the noise. 

Dave Garber kindly loaned us the airplane fuselage, trailer and truck to display 
and run it in the run up area next to the rotary engine workshop tent. The 12A HP
measured on Racing Beat's dyno is 330 HP at 8500 RPM and 75 inches of Hg. The 
PSRU ratio is about 3.3 to one and the top speed of this airplane is around 
400 MPH. Minimum BSFC for a normally aspirated peripheral port 13B occurs 
around 6000 RPM so that would be a good cruise RPM provided you had enough 
pitch in the prop to absorbs the available HP at that RPM. Dave uses large 
diameter fixed pitch three bladed props with a bunch of pitch and states 
the 2400 pound airplane with a 20 foot wing span takes off at 120 MPH on 
only one engine. 

I demonstrated 4000 RPM at 50 inches of mercury manifold pressure during the
static run ups. We need to sell the Motec EFI controllers and replace 
them with a set of Tracy's EFI controllers as the engine was missing occasionally.
The Motec's use throttle position which makes little sense for a turbo engine.

Needless to say this engine made a big impression on everyone who saw  and 
heard it run. BTW I did not think it was that loud. Vlad measured the db 30
feet away at 110 db. I of course was wearing ear muffs and we passed out free
ear plugs the first day. 

We are developing a program to tow the airplane out to California, test fly it
and develop the cooling system with the goal of racing it in the Sun 100 next year.
It is quite capable of easily beating this years overall winner the Thunder Mustang.
The rads are plenty big enough and not too thick so we just need to convince the 
air to go through them. We will use several solid state data acquisition
systems and pressure sensors as there is no room in the tiny cockpit
for a water manometer.

We are looking for donations of $1000 minimum each. I don't have the
exact number cast in concrete yet but my guess is our first year's budget
will be about $25,000. Second year follow on program would be to install two
900 HP turbo three rotors with a try at the unlimited class at Reno. The PSRU's
are rated at 1000 HP each so the 900 HP three rotors would be no problem. 

On the other hand Dave is willing to sell the airplane as is for $100,000 
if anyone is interested.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org