Subject: Just made it back.Dave Garbers Reno racer. and LAEV prop.
From: ACRE NL
Date: 4/18/2002, 5:59 AM


Needless to say this engine made a big impression on everyone who saw  and
 heard it run. BTW I did not think it was that loud. Vlad measured the db 30
 feet away at 110 db. I of course was wearing ear muffs and we passed out
free
 ear plugs the first day.

   I thought the engine exhaust noise was being covered by the propeller
noise. No worse than a 4 cylinder piston engine. Nice to meet you all. That
propeller project is just wonderful. If I could have gotten that far, I would
not have slept until it was finished.

Lynn E. Hanover

Nice meeting you too Lynn.

Lynn is referring to the LAEV prop by Butch Dias.
The electric variable pitch prop is designed to bolt to Tracy's PSRU.
This will allow a high HP, high reduction PSRU ratio with a low RPM high pitch
cruise setting for maximum MPG at any given speed.

One of the many features is the solenoid controlled brushes that drastically
reduce wear on the brushes.

Here are a few pictures. Perry Mick will be building some carbon fiber
blades shortly and we will devise a severe torture stand to test the prop
under the rotary engine's high power, high RPM  and gyroscopic loads.
This is not designed to fit a A/C piston engine as large 4 cyl piston engines 
have much more severe torque pulses. We will not test it on a A/C piston engine
nor do we recommend doing that.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org