Subject: MM ATTACH TO FIRE WALL BRACKETS
From: ACRE NL
Date: 4/18/2002, 10:46 PM

Jerry Hey wrote:

Paul,  I came up with these little brackets for attaching the MM tubes
to the firewall for composite aircraft.  They allow a normal saddle
weld.  I have called for 3/8" bolts but I think 5/16" would be o.k.
Jerry

I am not sure I understand what you have in mind here. If the motor mount tube
welds into the center of the 3/4 tube it should be plenty strong and
5/16 bolts would be plenty big enough. 

This is what I use. Just a 4130 1.75 by 1.75 inch square .090 plate with tiny 
gussets every 90 degrees and with four 1/4 inch bolts per tube.
A similar aluminum plate on the other side to distribute the bolt 
tension loads. All the 4130 steel you see here weighs less than six pounds.
I use 3/4 .049 for the two outer lower tubes and 5/8 .049 for everything
else. The mount will take 1800 pounds of download (six G 300 pound engine) at the 
rubber bushing end.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org

Engine_mt_attach_bracket.jpg

mot-mount-align.jpg