snip
To provide the same comparison with 200hp, I will need a
credible power curve for a 200hp Wankel. The results will
be different if this added power was provided by porting,
supercharging, turbocharging, or the advertizing department.
Vance
Vance W Jaqua wrote:
Since I asked for a credible 200hp curve - this must have been an
early APRIL FOOL. This is one of the least credible power "curves"
that I have ever seen. I have no problem with the 200hp, but the
shape and slope of this "curve"???? A drop of almost half the
power in 300 rpm? this would be such a crummy engine, that
with a fixed pitch prop, you would be lucky to get enough
thrust to taxi to the gas pump. - Vance
(sorry to send this during down time - but I just could not sit on it)
Which one was that Vance? I forgot. Perhaps it was a prop load curve.
Here is a Lyc prop load curve verses a rotary dyno load curve for a 215 HP
at 6000 RPM peripheral port rotary engine built by Power Sport.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org