Joseph Berki wrote:
Hi,
Does anyone have a source for A/C evaporators for use as a radiator? I
have searched the web and found that everything is keyed to make and model
of the auto it goes in. That does not help with dimensions and cubic
inches. If you take one from a salvage yard to determine size then order a
new one from a supplier, seems like there should be an easier way. I know
the salvage yards could probably come up with several but how does one
test the integrity of a component that has questionable history. Like mom
use to say "Don't put that in your airplane, you don't know where it's
been". Thanks for any help.
Joe Berki
Limo EZ
Working out details for exhaust augmented cooling
Why don't you just use a new rad under the engine? Get a free Summit Racing catalog
and there are a bunch of different sizes of all aluminum rads to choose from.
Admittedly evaporator cores work pretty good as Tracy has been flying around for
seven years with only one out of the two he has in there actually working well:-)
(Mazdas are half as hard to cool as we thought :-))
Paul Lamar
Joe here is some background info on why automotive rads are better than evaporator
cores. I suggest you buy the Kays and London book. This is a serious and extensive study.
The Navy spent millions on this heat exchanger study over a period of years and the
book is a compilation of that data. Here are a few excerpts from that book.
You need a thin rad to get the air to go through
at takeoff speeds. Tracy had a lot of trouble with his evaporator cores
and he was not entirely satisfied with the results. Two of these might work
with 150 HP but you will need to put plenty of vents and cooling flaps
to encourage the air to go through the thicker cores.
BTW Tracy is using a thin oblique mounted automotive rad on his new RV8.
If you want to experiment with augmented cooling all well and good but
it should be done on the ground. The airport pattern is not the place
to experiment with new cooling schemes. If your engine over heats on takeoff
it can pump the coolant over board in a matter of minutes. You then risk very
expensive repairs to your engine. It is not like a car. You cannot just
pull over to the side of the road and stop. At a minimum you can fry
the water seal O-rings.
Paul Lamar
I'm getting by with an incredibly small radiator. I forget the exact
dimensions now, it's only about 14 x 18 x 2 overall including tanks.
But I think it is about the minimum, and would probably not be
sufficient if you are turning more than 5500 RPM or using a
super/turbocharger. But it's difficult to fit anything larger on a LEZ.
--
Perry Mick
Duckt N7XR
http://www.ductedfan.com
Perry did not mention that his prop also turns at 5500 RPM and sucks air
out of the rad like mad.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org