Subject: MM ATTACH TO FIRE WALL BRACKETS
From: ACRE NL
Date: 4/19/2002, 2:07 PM


Jerry Hey wrote:

Paul,  I came up with these little brackets for attaching the MM
tubes
to the firewall for composite aircraft.  They allow a normal saddle
weld.  I have called for 3/8" bolts but I think 5/16" would be o.k.
Jerry


I am not sure I understand what you have in mind here. If the motor
mount tube
welds into the center of the 3/4 tube it should be plenty strong and
5/16 bolts would be plenty big enough.

This is what I use. Just a 4130 1.75 by 1.75 inch square .090 plate
with tiny
gussets every 90 degrees and with four 1/4 inch bolts per tube.
A similar aluminum plate on the other side to distribute the bolt
tension loads. All the 4130 steel you see here weighs less than six
pounds.
I use 3/4 .049 for the two outer lower tubes and 5/8 .049 for
everything
else. The mount will take 1800 pounds of download (six G 300 pound
engine) at the
rubber bushing end.

Paul Lamar


The bracket is an alternative to the flat plates. I like the length of
the saddle weld (mm tube to this bracket) and I don't want to fuss
around with the little gussets. It can be sized for whatever tubing you
are using in the engine mount.   Jerry


OK It should work fine. Looks like extra work but it should adapt to any
tube angle real easy so they could be mass produced. Jerry, what about
a swing
away motor mount? That would be nice to have to work on the back side
of the
motor.

Actually, I can build  these faster than the flat  plate/ gusset
combo.   At first glance the swing away looks doable.  Just a hinge at
each corner.  Pull the pins on the side you want to open.
A future project.    Jerry

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org