Jerry Hey wrote:

Paul,   This is the table top.  There will be a heavy steel structure
underneath to ELIMINATE the possibility of heat distortion.
Removable corner plates, a set for each design.  Once I accepted this,
there were no further design issues.    What do  you think?    Jerry

Looks good. The drawing is a bit hard to read. Perhaps you can scan it bigger.

A universal motor mount jig is going to go a long way towards reducing 
the cost of custom motor mounts. Keep up the good work Jerry.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org