Subject: Evaporator cores a book
From: ACRE NL
Date: 4/22/2002, 2:59 PM

Perry Mick wrote:

I'm getting by with an incredibly small radiator.  I forget the exact
dimensions now, it's only about 14 x 18 x 2 overall including tanks.
But I think it is about the minimum, and would probably not be
sufficient if you are turning more than 5500 RPM or using a
super/turbocharger.  But it's difficult to fit anything larger on a LEZ.

--
Perry Mick

Perry did not mention that his prop also turns at 5500 RPM and sucks air
out of the rad like mad.

Paul Lamar

Joseph Berki wrote:

Paul, Perry,

The reason that I was considering evaporator cores was that I intended to
use exhaust augmentation to assist pumping air through the radiator.  The
inlet in my proposed design has a direct shot at the radiator, which is in
optimum orientation to the air flow, after 41" it expands to the dimension
of the radiator and then  converges into a 6.5" augmenter tube 24" long
after the radiator.  There is a slight bend just after the radiator .  I
have no intention of flying this until it is proven on the ground.  I may
also get a radiator built if I can't get the packaging with the evaporators
right.  Thank you for the information.

Joe Berki

I think having the air go straight through the rad is overrated.
If the duct is done right the velocity should be low. The other important
thing is turbulence in the core itself. Forcing the air to make
a right angle going into the core could enhance turbulence in the core.

Here are some coordinates & charts for a straight in duct Joe.
This data is post WW II.

Paul Lamar


Joe:  Keep pursuing that idea.  I think you will need some assistance for
ground cooling.  In my early ground cooling tests the engine would eventually
overheat on the ground idling with my fan duct removed.  I expect it would do
the same if I had a psru/prop.  That's one reason I haven't chucked the duct
yet, as what I have works.  I did have an electric cooling fan on the rad in
the early ground tests.  It was turned on by a temperature switch in the
coolant system.  But I think it was removed long before first flight since it
wasn't required with the ducted-fan.

--
Perry J. Mick
Duckt N7XR
http://www.ductedfan.com

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org