Subject: Stationary Gear Removal (20B)... Never mind
From: ACRE NL
Date: 4/22/2002, 11:10 AM


Tom Kendall wrote:

I can't seem to get the stationary gear for the middle rotor out of my
intermediate housing (doesn't apply to 13Bs... one of those unique 3
rotor
problems).

I've removed the capscrews that *appear* to be holding it in place,
banged
on it with a dead-blow, and tapped on it with a hammer.  Won't budge.
Is
there some kind of trick, or am I just not using enough force?  I'd hate
to
find out too late that there is a taper pin or some other such device
holding this together!

Any ideas or experience?

Tom Kendall

I don't know anything about that. I think Bruce has the 20B overhaul tape
available at Tracy's. Is that true Tracy? I'll send a copy of this to
Bruce Turrentine.
Also call Mazdatrix and ask for John. He is the engine overhaul guy and he
does
20B's as well.

Paul Lamar

Uh... never mind everybody.  Today I went to pick up the offending
intermediate piece by the stationary gear and the gear popped right out.
Seems it was loose all along.  This here rocket scientist here figured it
just *had* to go out the other side of the intermediate piece, so I had set
it on wood blocks and started beating the gear down *into* the rabbeted
recess that held it.  Probably woulda worked better if I had started out
using the dead blow on my own noggin' first ;-)

Tom "the hammer" Kendall


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org