Subject: Main Bearing Oil Clearances
From: ACRE NL
Date: 4/23/2002, 8:07 PM


 I can't figure how the clearance could be so large on
 > an essentially new engine.
 >
 > Here's what I have:
 >
 >                                 Main Bearing Clearance
 > Front Rotor                        0.0038"
 > Center Rotor                    0.0033"
 > Rear Rotor                        0.0036"
 >
 > Each of these is above the spec range of 0.0016" - 0.0031"
 >
 > The rotor bearings are right in there with 0.0022" - 0.0024".
 >
 > Does this make sense to anybody?  Did Mazda provide increased oil
clearance
 > on these 3 rotor engines?  I would really hate to press out the babbit on
 > good bearings... I'll probably screw it up if I do.
 >
 > Any suggestions welcome.


     If it was my engine I would just put it back together. The journals are
long and large in diameter. When I raced a Fiat (yes it has been done) I ran
.004" on the mains and .0035" on the rods. Ran the same main bearings for
years. The rods did well but when they get a shine on them I changed them. I
pay extra for racing bearings that are advertised as being .0005" oversized.
A little loose is a lot better than too tight. For big bearings extra
clearance would seem the smart move. When we scream the engine the crank
takes on an "S" shape and shines the ends of the main bearings. It doesn't
seem to hurt them any. I wipe off the shine with 600 wet or dry paper in the
cleaning tank. The best RPM my driver has come up with so far is around
11,000. Just run it up to 9,500 RPM in second gear and stick it back in first
while going for third. Be sure to let the clutch out to be sure its in first.
It shines the bearings up real nice. It scuffs the corner seals a bit and the
corners of the rotors drag a bit on the side housings. The engine ran fine
and finished the weekend.
Aircraft use will be close to a 100% duty cycle. Full throttle for hours on
end. More stress in many ways then racing will impose.
Lynn E. Hanover

Except when you climb up to 10,000 feet normally aspirated.
Then you are down on power a bit.

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org