Subject: Other ways of changing the pitch.
From: ACRE NL
Date: 4/23/2002, 8:14 PM

Snips...

Paul,

I knew I would get myself in trouble with my LAEV post. I am a retired
electroniker who got turned into a manager many years ago, not an
electrical
machine type, but I can broadbrush a design so the group can
understand the
idea and be involved in any development if they wish. Initially,
assume the
use of the existing LAEV DC motor.

A design would start from a definition of the prop pitch change
requirements.
If you must drive the prop pitch at low or 0 engine RPM, for ground
test or
in-flight feather, then you will have to generate AC drive power (it
can be a
simple square wave) on the airframe side and couple it to the prop
side
through a rotary transformer. These are transformers with a circular
air gap
between the primary and secondary so they can rotate relative to each
other.
Somewhat inefficient due to the air gap but they can be overdriven for
short
time pitch changes. We considered using these on the JPL/Galileo
spacecraft
instead of sliprings for power and data transfer between the spun and
despun
sections. These rotary transformers would definitely be custom
devices.

For minimal changes to the existing LAEV, the AC power coupled into
the hub
could be rectified, filtered, and regulated, within the spinner, to
drive the
existing DC motor. AC power off - no motor drive. AC power on - motor
drives,
but only in one direction. We also need a direction switch within the
spinner. Simple electronics but we also need a way to control the
switch.
There are several non-contacting ways to provide a direction signal,
another
rotary transformer or a higher frequency signal riding on the AC power
waveform or a substantial change in the AC frequency could be used as
a
signal. Operation would be, AC power off - no drive, AC power on and
signal
off - CW drive, AC power on and signal on - CCW drive.

If there is no requirement for 0 or low RPM pitch changes then the
power
required can be supplied by a multipole alternator on the prop shaft.
Multipole to get the frequency up to a reasonable level, 1200 RPM is
only 20
RPS or 20 Hz from a two pole device. The same electronics as above
could be
used to to control the DC motor. This alternator would be an
inside-out
device with DC excitation on the outside fixed part. Not a permanent
magnet
type so the AC can be killed by shutting off the DC excitation. It
probably
would have to be a custom device, but a good machinery guy might know
of
something this old geezer never heard of. Again, the excitation could
be
modulated for a direction signal.

Any interest ?

Fred O


[Todd Carrico]
<Sanity check>
Not to rain on your parade... since we don't know if wear is even an
issue with the MT etc., is it really a good idea to try and engineer a
solution that is more complicated, and heavier than the tried and true
slip ring?  Just trying to get the most bang for our engineering buck
<grin>.
</Sanity check>

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org