Ken Welter wrote:
Yes and as you remember I told you at Arlington last year
that
Jim
was a accident waiting for a place to happen as the engine
installation was a compleat abortion and in addition to that
he
had a
aft CG problem and he would not listen to me about it and I
told
him
that it would be prone to stalling and spinning in the event
of
a
engine failure, then a couple months ago on a taxi test when
he
lifted the nose wheel off the ground the nose came up and
with
full
stick forward he could not get the nose down and it stalled
at
about
ten feet off the ground braking the nose gear and one main
gear
and
damaging the hull. He repaired the damage but I do not know
if
he did
anything about the weight and balance but you would think he
would of
at that point.
Ken Welter
Its always particularly sad to learn of an accident that likely
could have
been prevented. You can fool yourself and perhaps others, but
you
can not
fool the laws of physics and aerodynamics - at least, not for
long.
I did
not know Jim, but my condolences go out to his family and those
who
did
know him.
Ed Anderson
What doesn't make sense here is how he got an airworthiness cert if
his
W&B was
off. FAA (and presumably DARs) are pretty strict about W&B calcs; at
least my
FAA inspector was.
Finn
Yes but do they actually check it or do they check just the paper
work?
There is a saying in the professional A&P world. "I pencil whipped
it."
Meaning I signed it off without actually doing the work. In my
experience
the FAA rarely checks anything other than the paper work.
Paul Lamar
Just wait until you have a ramp ck.
Joe
Oh oh! I think I just pissed off the FAA. I am sure they will now come out
to my airport (unamed on purpose) and wait until I bring it out of the
hangar :-)
I'll make sure I have all my paper work in order :-)
Paul Lamar
Paul,
Did not nean to offend anyone.
My plane was grounded at an airport some distance from home and I had to
replace some sheetmetal screws that were SLIGHTLY corroded, resafety a turn
buckle with double wrap instead of single, and a few other nitty stuff but,
the paper work was fine. So, I learned a lesson from travel expense, tie
down fee, and A & P labor. No I am not the FFA.
I gain a lot of information from your pages. Keep it up.
Thanks again
Joe
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org