Subject: Other methods of changing the pitch.
From: ACRE NL
Date: 4/24/2002, 6:47 AM


2) Use an ELECTRICAL approach.  Again, place the "generator coil" in the
spinner.  This coil would cut across electromagnetic fields generated by
an "electromagnet coil" mounted to the stationary engine/PSRU.  The
stationary electromagnet can be electrically powered to introduce
variable amounts of current in the spinner coil, even reversing polarity
to drive it in opposite directions. Pros: Can be entirely an electrical
solution, mininal moving parts.  Cons: Draws upon aircraft electrical
sources.

It is not that simple. If you put a coil on the spinner it  will pick up the
magnetic field from the permanent magnet or electromagnet mounted outside.
However, the induced voltage  will be always AC. The direction of current
driving the motor will be defined by the direction of diodes in the
rectifier (mounted in the spinner) and it will not depend on flipping of the
magnetic field of the outside magnet or electromagnet.  Flipping the
external magnets would change the phase of the AC only.

If you want to reverse the voltage driving the motor in the spinner, you
would have to use synchronous rectifier made of transistors. The system
would have a bunch of permanenet magnets to deliver power, and a small
electromagnet that would "tell" the synchronous rectifier which way to
rectify, positive or negative.

A little more complicated but doable.

Jerzy

You got me on that one ... embarrasing.  OK.  So, without putting some
controls somewhere in the system, you can only generate AC in the
spinner.  I got it.  (I hope I didn't throw anyone off with my last
post...)

This leaves us with two choices:
1) put the controls under the cowl (or other stationary aircraft areas)
2) put the controls in the spinner

Controls under the cowl:
------------------------
Same idea as originally proposed above by me (#2 - electrical approach),
except that the coils would need to be driven in an AC fashion, in sync
with prop/spinner position.  Pros: no moving parts (other than the
requisite pitch control DC motor).  Cons: Driving current draws from
aircraft electrical supply, synchonizing coil's + & - polarity with prop
is essential, and control circuit is complex.

Controls in the spinner:
------------------------
Jerzy is pursuing the "permanent magnet" approach: Permanent magnets
mounted on the stationary engine/PSRU, with generator coils in the
spinner.  Some other "control" (like compact electromagnet(s) near the
prop shaft center) would tell electronics in the spinner which way to
rectify (+ or -).  Surely there is a way to design a (+ off -)
arrangement without much trouble, (which I'd think is a requirement).
Pros: very little aircraft current required to SIGNAL the spinner's
rectifier circuits, no synchronizing issues, no moving parts, and prop
horsepower to drive pitch motor is negligible.  Cons: I can't think of
any.  I like this idea.

OK, so when do we build and test it?  :)

-Vince

--
Vince Orton
Starting RV7 soon ...

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org