Subject: Other methods of changing the pitch.
From: ACRE NL
Date: 4/24/2002, 6:50 AM


Jerzy
It is not that simple. If you put a coil on the spinner it  will pick up the
magnetic field from the permanent magnet or electromagnet mounted outside.
However, the induced voltage  will be always AC. The direction of current
driving the motor will be defined by the direction of diodes in the
rectifier (mounted in the spinner) and it will not depend on flipping of the
magnetic field of the outside magnet or electromagnet.  Flipping the
external magnets would change the phase of the AC only.

If you want to reverse the voltage driving the motor in the spinner, you
would have to use synchronous rectifier made of transistors. The system
would have a bunch of permanenet magnets to deliver power, and a small
electromagnet that would "tell" the synchronous rectifier which way to
rectify, positive or negative.

A little more complicated but doable.


Fred Osborn wrote,

Thank you Jerzy. I was beginning to think I missed something really remarkable in
my many years as a manager, a true commutatorless DC generator. I swore that I
could remember that Electrical Machinery prof telling us "there are no DC
machines, only AC machines with commutators".

You can make a DC generator (I think) by "commutating" the electrical excitation
on the stator (engine) side with solid state electronics but as you point out you
need a shaft angle sensor of some sort with electronics to tell the "commutator"
when to switch. That way the electronics can all be on the stator side.

The wound stator of a multipole pancake brushless DC servo motor would probably
make a good generator stator but I do not know if you can find a corresponding
wound rotor. The rotor should be mounted directly on the prop shaft with the
stator concentric around it. The less the runout the smaller the gap can be.

Given Paul's guess of 100 to 150 watts, which seems high to one who knows
absolutely nothing about it, I would guess that a minimal generator could be
driven to that level for a few seconds, depending on how hot it normally would
be.

Fred O.


 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org