[Todd Carrico]
<Sanity check>
Not to rain on your parade... since we don't know if wear is even an
issue with the MT etc., is it really a good idea to try and engineer a
solution that is more complicated, and heavier than the tried and true
slip ring? Just trying to get the most bang for our engineering buck
<grin>.
</Sanity check>
Todd,
I agree completely and my experience with slip rings was with operation in a totally controlled environment (or so we thought). There is obviously a trade off between brush pressure, brush and ring material, wear, contact resistance, and susceptibility to contamination. Each combination of "killers" is unique and if the prop pitch hangs up it should not be a critical failure. Still I would worry about the reliability long term because you cannot predict reliability from a tried and true design for a different environment.
If the slip rings will hack it, that is the way to go, we agree.
<grin back to you>.
Fred O.
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org