Subject: Synthetic oil why not?
From: ACRE NL
Date: 4/28/2002, 6:36 PM


Jerry Hey wrote:

On Sunday, April 28, 2002, at 09:38 AM, ACRE NL wrote:

Royce Wise wrote:

I don't know what I did with it, but I think there was a post about
not using
synthetic oil in the rotary.
Anyone remember that post?
Royce

I searched for the key words Royce AND synthetic and I found nothing.

Paul Lamar

My 1988  RX-7 owner's manual says, "DO NOT USE SYNTHETIC OIL."
Jerry


Yes but they don't tell you why not or what brands. Some are using
Mobil 1 with
no apparent problems. I tried soaking the green Oil O-rings
in Mobil 1 with no apparent problems.

Paul Lamar


I would not assume they did not have good reason for this admonition.
Jerry


The only thing wrong with synthetic oil is:  It is not designed to burn!  If
you use an oil metering pump on your rotary, you will be injecting an oil that
may leave deposits of who knows what?  For sure they will be created at a much
higher temperatures than "normal" 30 Wt. and will probably be even more nasty
and sticky on apex seals and slots.

Racing Beat uses their own "approved purple synthetic" in the sump ... but they
mix 2-cycle oil at very high ratios on their high power output engines.

Owner's manuals will not tell you to lose the metering pump ... for emissions
purposes.

Dale Smith


I just tried to burn some Mobil 1 and gasoline in a glass. The fire
went out before the Mobil 1 burned completely. Maybe none at all.
there was a little discoloration on the side of the glass.
This is not to say it may not burn differently in the combustion chamber.
Our early test where we heated it to 500 degrees in an industrial oven
also indicated it had difficulty breaking down at that temp.

Then I soaked a piece of paper in the Mobile 1 and tried to burn that.
Again the fire went out before the paper was complexity burned. What
was left was the most heavily soaked paper. Try it. It is fun.

I tend to agree with Tracy. Un burnt oil is making its way to the
catalyst. Tracy noticed that his sump level would actually increase
as some of the apex seal oil was finding its way to the sump.

I have some WalMart 2 cycle oil. I will mix that 50 50 with gas
and see if that burns.

Paul Lamar

It will.
Royce

 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org