Jerry Hey wrote:
Paul, on your drawing of the pp modification you have the
instruction to "Port the Inner Part with a die grinder to square
it up," what are your referring to? Does the port transition
from round on the outside to square on the inside?
Yes. Here is a picture of a racing beat PP.
The drawing is of Ken Powell'e variable timing PP but
it shows the dimensions of the square. You should round off
the corners.
Can you provide a drawing showing the inner
shape? Also, is there a throttle body available as you have
drawn it, or one that can be modified? Jerry
You will have to make that part. Two throttle bodies are used. One
for each rotor housing. Gives a better idle when the butterflies
are close to the rotor housing.
Paul Lamar
Paul and Jerry,
I would love to see the variable PP design installed and tested.
Jerry, would you
be interested in installing the variable PP intake valves that Paul
built? I would be happy to send them to you if you are interested.
It is thought by some that a PP motor with large amounts of
overlap
has
somewhat poor idle characteristics due to exhaust gas dilution of
the intake charge. In order to minimize this intake charge dilution
we decided to use the same technique that are used on 2-stroke
racing motorcycles, i.e., vary the port timing on the intake port.
A secondary benefit is that at small throttle settings the velocity
of the intake charge is accelerated while in the intake port,
further promoting fuel atomization. Also note that the BSFC should
improve at cruise due to the more conservative port settings.
A slower idle is important because even at 700 - 800 prop rpm a
highly pitched
prop will generate lots of thrust. Since the Fast Glass and the
RV's are difficult to slow down a slower prop speed is beneficial.
Note that a 1200 rpm idle (engine) when used with a 2.85 redrive
will result in a prop rpm of only 421 rpm, a substancial reduction
over a 1800 rpm idle and a 2.17 redrive wich results in a prop rpm
of 830 rpm.
Ken Powell
Ken I am interested and I would like to have the variable intake
valves. However, I need to say that it would be some time in the
not near future before I could install them. First, I will try to
build a simple PP port and see how that goes. Jerry
Hi Jerry,
Please send me a mailing address and I will send you the variable PP valves. Note
that they need to open from top-to-bottom, rather than from bottom-to-top as
depicted in all the drawings. (Have you had a chance to look at Paul's drawings on
his website?) This is because we are trying to minimize the exhaust gas dilution at
idle while maintaining the overlap at WFO. Also, have you considered 'in-port' PP
valves for the conventional PP setup. This is the setup used by Suzuki and
Powersport to enhance idle qualities. If anyone from your area is attending the
Memphis flyin (Rotormotor) over Memorial Day weekend I could just let them bring
the valves to you.
Ken Powell
email: kenpowell@alltel.net
ken.powell@alltel.com
home phone: 501-847-4721
office phone: 501-220-8622
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org