Hi group,
I send you a drawing of my dry pan/support.
The one you see is for a single rotor,I can do the
same for 2 or 3 rotor.
It is made out of aluminium 6061 t6 3/4 inch,CNC
machine.
You can see the bores to insert Lord rubber.
The oil pump inlet is not shown but it is there!
For those who are interest,here is my email.
cgtyy@yahoo.ca
Thank you
Frank
How much Frank? Neat idea.
Paul Lamar
Francois St-Germain wrote:
Thanks Paul,
The one rotor support cost around 550$ US
For the 2 or 3 rotor it will be something like 800 or
900 I do not know yet, But I will not make a living
out of this!
I have forgot to mention that it can be insert between
the original Pan and the engine to act as a simple
engine mount.
Thanks
Frank
Very elegant solution to motor mount brackets Frank.
That is the trouble with those NC mills. They are expensive and
they MUST be paid for.
Paul Lamar
The AirCraft Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/ http://www.linux.org