Subject: Ernesto's turbo Cozy motor mount.
From: ACRE NL
Date: 4/30/2002, 3:52 PM


This uses the motor plate idea or the new cast bell housing idea.
It is like the Kis Cruiser but the tripods are reversed and attached up
near the top of the spar and down near the landing gear pivots.
Gives plenty of room along side the engine for the HKS manifold
and TO4 turbo.

I still need a bunch of dimensions Ernesto.

Paul Lamar

Thank you for wanting to help me.
My firewall is a flatten oval, 38" wide by 31" tall.
W.L. 34, top of firewall
W.L. 23.5, B.L. 16.5, stock engine mount to firewall holes, left and right
W.L. 22, top of spar
W.L. 21, Crank shaft, C/L of motor
W.L. 20.25, B.L. 36.5 inside wing mount bolt holes, 0.5", right and left
W.L. 17.4, trailing edge of wing.
W.L. 14.6, B.L. 7.0, stock bottom engine mount holes, right and left
W.L. 3.0, Bottom of firewall
Firewall to prop face needs to be 41"
Thrust line is 1.5 degrees up from C/L of motor
Spar is flat behind (.25") the fire wall until about B.L. 34 then sweeps
back about 10 degrees just before the wing mount holes.
Thanks again Paul!
Ernesto


W.L = water line
B.L = ????

Paul Lamar
 
The AirCraft Rotary Engine NewsLetter.              Powered by Linux.
ACRE NL web site. Copyright 1998-2002 All world wide rights reserved.
http://home.earthlink.net/~rotaryeng/            http://www.linux.org